The terminal machine refers to a machine used for wire processing. It presses the five gold heads to the wire ends and then conducts them, so that the terminals can be connected without welding. The operation is simple and convenient. The common problems encountered during operation and how to solve them are explained below:
1. The terminal machine fails to start or stops halfway
First, don't panic in this situation. If it is stopped halfway, close the program first, check whether there is current input (220V) and 6kg air pressure, then check whether the set total quantity has arrived, whether there are wireless materials or some operating parts are stuck, and then check whether the terminal machine is not pressed due to signal connection or power connection.
2. Uneven copper wire leakage of pressing terminal
To produce this phenomenon, we need to check step by step. First, check whether the gun type swing arm conduit is consistent with the wire. Second, check whether the knife edge of the terminal machine is relatively straight with the swing arm conduit. Then, check whether the auxiliary pressing block of the terminal machine is loose. Finally, check whether the distance between the terminal machine and the automaton is changed. After this series of checks, the cause of the fault can be found.
3. Inconsistent cutting length of electronic wire
This situation is mainly caused by three reasons. First, the wire feeding wheel is pressed too tight or too loose. If this is the fault caused by this phenomenon, we only need to adjust the gap between the two wheels with the wire roller trimmer so that the wire is not flattened, too loose and slipping, and this problem can be solved; Secondly, the straightener is too tight or too loose. In this case, we should adjust the straightener so that it can straighten and send out smoothly; Finally, the cutting edge is worn or the cutting edge is damaged. In this case, we only need to replace the corresponding model of cutting tool.
4. The machine is in continuous beating condition
In case of this kind of situation, first check whether the mechanical part is stuck and whether the reset is flexible. If there is no problem, check the circuit condition and try to replace the circuit board and relay to solve this problem.
The above are the common problems and solutions of the terminal machine. Some of them come from Baidu, and there may be other problems. You can consult Dongguan Ruixin automation at any time. It is a manufacturer specializing in R & D, production and sales of automation equipment, with qualified technology and rich and reliable products, It mainly includes: crimping machine automatic terminal machine | automatic terminal machine manufacturer | automatic tin dipping machine | automatic tin dipping machine manufacturer | full automatic crimping machine | wire harness crimping machine | connector wire harness crimping machine automatic crimping machine Ruixin automation
